HOW TO RE-GRIP

REGRIP YOUR ENTIRE SET IN 30 MINUTES
FOUR THINGS YOU'LL NEED
  • Vise and rubber vise clamps
  • Straight blade or utility knife
  • Two-sided grip tape (3/4" or 2")
  • Mineral Spirits Grip Solvent

SECURE THE SHAFT

Use a vise to secure the shaft near the tip of the grip using a protective rubber vise clamp. Position the club face perpendicular to the floor in the playing position.

PRO TIP

Take a few minutes to watch our Re-Grip Video for visual instructions.

REMOVE THE OLD GRIP

Using a straight blade or stripper, remove the old grip. Be sure to cut away from yourself at all times. Peel or scrape off the old grip and grip tape. Using a cloth and Mineral Spirits Grip Solvent, clean off the residue.

PRO TIP

Use a utility knife with a hook blade on graphite shafts to avoid damage to the shaft.

MEASURE FOR TAPE

Hold the new grip parallel to the shaft to determine how much area needs to be covered by the tape.

APPLY THE TAPE

Use either 3/4" or 2" double-sided grip tape. If 3/4" tape is used, wrap in a spiral formation from the top of the shaft to the point where the bottom of the grip will be on the shaft. Remove the tape backing and cover the end of the shaft with extra tape.

PRO TIP

Apply build-up tape on the shaft if an oversize grip is desired.

CLEAN WITH MINERAL SPIRITS

Cover the vent hole in the butt end with your finger or golf tee, and pour a generous portion of Mineral Spirits Grip Solvent inside the new grip. Close the open end of the grip with your hand and shake to cover the entire inside of the grip.

POUR MINERAL SPIRITS OVER

Pour the excess Mineral Spirits Grip Solvent (through the vent hole) over the entire length of the two-sided tape. Apply generously. Use a tray to catch excess Mineral Spirits Grip Solvent for use on other clubs.

APPLY THE GRIP

Place the grip over the shaft butt (with the alignment pattern up) onto the club by squeezing the open end of the grip. Push the grip entirely onto the club. Be sure the grip butt is against the shaft butt.

PRO TIP

Be sure to do this while the grip tape is still wet with Mineral Spirits Grip Solvent.

FINAL PLACEMENT

The grip can now be properly aligned with the pattern square to the club face. (This must happen within a minute or so after applying the grip.) Allow grips to dry several hours before playing.